Nortel Networks FastRad manual Programming Data

17

This completes alarm programming. To continue programming FastRAD call handling, refer to the next section, Programming Data.

Programming Data

Data programming allows you to determine how many seconds the FastRAD waits before answering a call on an incoming KSU line. This allows a line to be used normally during business hours and provides Auto-answer capabilities after hours. Auto- answer must be set to ON to allow unassisted access to the FastRAD.

Before you begin programming, make sure the display shows RAD Admin.

If you do not have this display on the Norstar telephone, follow the steps in Starting a Programming Session.

To program the FastRAD’s Data:

1.Press DATA.

The display shows:	Auto-answer: OFF
	BACK	CHNG NEXT

2.Press CHNG to turn automatic answer ON.

The display shows:	Auto-answer: ON
	BACK	CHNG NEXT

3.Press NEXT.

The display shows:	Answer line:		001
	BACK	CHNG	NEXT

4.Press CHNG.

The display shows:	Answer line:_
	CLEAR	BKSP OK

5.Enter the KSU line number the FastRAD uses for remote connections. Refer to the Programming Record for the correct line number.

FastRAD Installation Guide