21
Troubleshooting Troubleshooting the FastRAD installation is needed if you start a programming session and the display shows
Inactive feature.
1.Check the wiring at the distribution block.
2.Make sure the Norstar port that the FastRAD is attached to is working.
3.Check that the power LED on the FastRAD unit is lit to confirm the power connection.
4.Refer to the appropriate Norstar Installer Guide for further diagnostic tests.
Note: If the wiring at the distribution block has been discon- nected, the FastRAD can take up to two minutes to reset after the wiring is reconnected.
After you have checked all the wiring:
1.Press ƒ·••. The display should show:
Enter password
EXIT CHNG NEXT
2.Press NEXT.
The display shows: | RAD Admin | |
| GEN | ALARM DATA |
If the display is still showing Inactive feature, repackage the FastRAD, and return it to the point of purchase.
