11
Starting a programming session
The FastRAD cannot be used for remote or direct connections until the user password has been programed through Feature 9**. This initial password programming must occur
IMPORTANT: There is no way to recover a lost or forgotten password or return to the default state.
A FastRAD is programmed from a Norstar
Note: You cannot start a programming session while you are on a call. When a programming session is in progress, press only the buttons indicated. The programming session is termi- nated when you press incorrect buttons or when you make or answer a call. Only on a DR2 KSU can you put the programming session on hold to make or answer a call.
If you need to go back a step while you are programming, press BACK or press ®and start again. If you stop programming for more than three minutes, the display returns to the date and time, and you must restart programming from the beginning.
IMPORTANT: You must wait 60 seconds before you attempt to
program the FastRAD when: the FastRAD is connected or restarted; the power supply is disconnected or the KSU is restarted.
To start a programming session:
1.Press ƒ·••.
The display shows: Password
EXIT CHNG NEXT
Note: When the password has been changed, the display
shows: Enter password. Check the FastRAD installation
wiring and start again if the display shows: Inactive feature. For more information, refer to Troubleshooting, later in this guide.
