Configuring Wireless LAN Settings from the Camera

Configuring a Network Profile

This section explains the steps introduced in “Configuration Overview” (c 126) in detail.

1 Choose [Network profile] from the [Wireless settings] option in the camera’s setup menu.

Press d to apply selection.

If a password has been applied (c 134), enter the password and press the shutter-release button. For information on entering text, see “Entering Text with the Camera” (c 127).

The camera will search for available SSIDs.

Wireless settings

Network profile

Sender

Address options

Picture Bank

Password

I

Searching for SSID

Cancel

Wireless

2 Choose the SSID and press d.

Up to ten SSIDs, with network profiles configured with the camera and those detected by the camera, are listed.

SSIDs with network profiles are listed first regardless of signal strength.

The icon to the left of each SSID indicates signal strength and is displayed in red when out of range.

Select SSID New

AP1

AP4

AP3

AP2 Back

Services

128

The icon to the right of each SSID shows the status of the camera’s network profiles:

Z (home wireless LAN profile configured), -- (no profile configured)

If connection by any wireless device is not allowed with an access point and the desired SSID (up to 32 alphanumerical characters) is not detected, select [New] and enter a network name (SSID) in the SSID screen. Press the shutter-release button.

Choose an SSID with a network profile and press d. Profile settings can be edited by following the same procedure used for SSIDs for which network profiles have not been configured. To delete an existing profile of an SSID, select the SSID and press T.

You can configure a maximum of ten network profiles in the camera. If ten have already been configured and you want to add a new one, delete an unnecessary profile using the camera or the Utility.