Notices

 

FCC/IC RF Exposure Statement

 

The available scientific evidence

Introduction

does not show that any health

problems are associated with using

power wireless devices are

 

low power wireless devices. There is

 

no proof, however, that these low

 

absolutely safe. Low power wireless

 

devices emit low levels of radio

 

frequency energy (RF) in the

 

microwave range while being used.

 

Whereas high levels of RF can

 

produce health effects (by heating

 

tissue), exposure to low-level RF that

 

does not produce heating effects

 

causes no known adverse health

 

effects. Many studies of low-level RF

 

exposures have not found any

 

biological effects. Some studies have

 

suggested that some biological

 

effects might occur, but such

 

findings have not been confirmed

 

by additional research. Wireless LAN

 

Module (GC-131) has been tested

 

and found to comply with FCC/IC

 

radiation exposure limits set forth

 

for an uncontrolled equipment and

 

meets the FCC radio frequency (RF)

 

Exposure Guidelines in Supplement

 

C to OET65 and RSS-102 of the IC

 

radio frequency (RF) Exposure rules.

 

Please refer to the SAR test report

 

that was uploaded at FCC website.

 

This device should not be co-located

 

or operated in conjunction with any

 

other antenna or transmitter.

vi

Notice for customers in the U.S.A.

FCC RF Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/television technician for help.