forwards into the internal drum cavity and withdraw the sheet.
CAUTION!
Do not use any sharp or abrasive objects to separate sheets from the belt. This may damage the belt surface.
>To remove a sheet from the central area of the belt (2), carefully separate the sheet from the belt surface and withdraw the sheet.
3
2
1
4
>To remove a sheet just entering the fuser (3), separate the trailing edge of the sheet from the belt, push the fuser pressure release lever (4) towards the front and down to release the fuser’s grip on the sheet, and withdraw the sheet through the drum cavity area. Then allow the pressure release lever to rise again.
NOTE:
If the sheet is well advanced into the fuser (only a short length is still visible), do not attempt to pull it back. Follow the next step to remove it from the rear of the printer.
Clearing paper jams > 166