Connecting to your PC using the cradle
Place the recorder on the cradle
1 Insert end A of the USB cable to your PC's USB port or USB hub.
2 Connect the end b of the USB connection cable to the cradle.
3 Make sure that the recorder is stopped, and place it in the cradle.
Hook
When you place the recorder on the cradle, 1insert the recorder so its bottom slot meets the hook on the front of
the cradle (at the low end). 2Hold the top of the recorder and push it against the cradle until it clicks.
“REMOTE” is displayed on recorder if the USB cable is connected.
Connecting to Your
Remove the recorder from the cradle
4 Make sure that the recorder's record/play indicator lamp isn't flashing, and remove the recorder from the cradle.
Hold the cradle with your hand, and raise the recorder from the top end to remove it from the hook, as shown in the illustration.
5 Disconnect the USB connecting cable.
······················································································································································
Notes
•Do not needlessly touch the connection point on the front of the cradle (at the low end), as that may cause damage resulting in a bad connection.
•Release the HOLD switch. (☞ P.9)
PC
51
