Olympus M1200 manual Clean the HYDRO-FILTER, Rinse OUT Recovery Tank

CLEAN THE HYDRO-FILTER:

Build-up of debris in the filter bag of the Hydro-Filter will reduce the vacuum air flow and may cause a significant decrease in water recovery. A torn filter bag will allow debris past the filter and into the recovery tank. This debris can clog the Waste Pump and the Vacuum Shutoff Assembly. The Hydro-Filter must be examined and cleaned regularly to keep the M1200 functioning properly:

•Push the latch lever and open the Hydro-Filter lid.

•Remove the filter bag. Examine the bag and clean or replace as needed.

•Rinse the body of the Hydro-Filter with clean water.

•Examine the o-ring seal and replace as needed.

•Re-install the new or cleaned bag.

•	Close lid and secure latch.		Repair parts are available for the Hydro-Filter:
			Filter Bag:	AC11A
			Parts Kit:	AC11B – (Includes Latch, O-ring & screws.)
			Lid:	AC11D
		FILTER BAG – AC11A

LID – AC11D

O-RING

LATCH

FILTER BODY

RINSE OUT RECOVERY TANK:

Build-up of fine silt and debris can damage the Waste Pump and Drain Valve. Clean out the tank on a regular basis to extend the life of these components as well as keep the tank and machine smelling better.

•Remove the recovery tank lid and open the drain valve.

•Place a bucket under the drain valve.

•Use a hose to rinse the dirt and debris out of the recovery tank.

•Close the drain valve and spray the tank with a deodorizer or disinfectant.

•Proceed to Waste Pump Cleaning and replace the recovery tank lid.

•Dispose of the dirty water and debris.

27