Olympus M1200 manual

WARNING! This machinemust beprotected from conditionswhich may damagethepump, tank,hosesandothercomponents.

•Freezing of water in this machine will cause serious damage. The M1200, solution hoses, and tools must be protected from freezing temperature. Store, transport, and use this equipment only in temperatures well above freezing. (32ºF or 0ºC). If you suspect the M1200 has been frozen, do not plug in or turn on machine until you are sure it has thawed completely.

•If the equipment cannot be stored or transported in a warm environment, it can be guarded from freezing by running an anti-freeze solution through the incoming water lines, chemical feed system, solution pump, solution lines, tools and pump-out pump. The machine is filled at the factory with anti-freeze to eliminate damage during shipment in cold weather.

oThe anti-freeze solution must be completely flushed from the machine before it is returned to service.

•The M1200 must not be used to pick up flammable or combustible materials or used in areas where these materials may be present.

•Solvent-based or water-based solutions containing solvents may damage the pump, hoses, and other components. Do not assume chemical compatibility. Contact your distributor or Hydro-Force if you have questions regarding the compatibility of your chemicals with the machine.

•Do not clean with solutions that are at temperatures above 180ºF.

•Rinse the solution tank, chemical system, and pump with fresh water after each day’s use.

•Do not allow pump to run dry. Always maintain adequate solution level to supply solution pump.

•HP hoses may rupture if worn or damaged. Do not use HP solution hoses if hose covering is cut, bulging, or otherwise damaged. Examine HP solution hoses daily and replace or repair hoses as needed.

•Use Hydro-Filter and clean the recovery tank daily to keep pump-out pump from becoming clogged. Store the M1200 with the recovery tank lid open.

•Keep Vacuum Inlet Filter clean and check float ball for proper operation. Do not operate the M1200 without the Vacuum Inlet Filter in place. Use defoamer to eliminate foam build-up during cleaning and prevent foam/moisture from entering vacuums.

***Usecommon sensetoprotect yourself andothers whileusing this equipment.***

•Keep pets and children away from the machine when in use.

•Keep all body parts, hair, and loose clothing away from openings and moving parts. Always wear appropriate clothing and safety equipment when operating unit.

•Use extra care when cleaning on stairs. Wet carpet on stairs can be slippery.

•Do not move the M1200 up or down stairs when tanks are full of water. Drain solution and recovery tanks before moving unit up or down stairs. Lift using only the appropriate handles.

•Water may be spilled, drip, or be exhausted from vacuums during operation. Place unit in area where water will not cause damage or use drop cloth to protect surfaces.

7