Omega Engineering CN 79000 manual If Edit is set to 1, jump to Addr on page

devices which do not have bias adjustments. Factory set to 100 for all output codes.

If Out1 is set for ##tP, #PUL, or ProP,then skip to S1LP.

S1rE Set Point Reset. Select OnOF or Hold.

OnOF Control will automatically reset when process passes back through SP1d.

HoLd Manual Reset. Reset (acknowledge) by simulta- neously pressing the INDEX & DOWN ARROW keys for 5 seconds.

S1Pi Set Point Power Interrupt. Select On or OFF.

On Alarm Power Interrupt is On. Control will automati- cally reset on power-up if no alarm condition exists.

OFF Alarm Power Interrupt is OFF. Control will power- up in alarm condition regardless of condition of process.

S1iH Set Point Inhibit: Select On or OFF.

On Alarm Inhibit is On. Alarm action is suspended until the process value first enters a non-alarm condi- tion.

OFF Alarm Inhibit is OFF.

S1LP Set Point Lamp: Select O on or OoFF.

Oon Lamp ON when Output is ON. OoFF Lamp OFF when Output is ON.

If Edit is set to 1, jump to Addr on page 33.

If Edit is set to 3, continue.

Page 29 of 40