One for All OARN05G Learning

1. Pressandholdthedevicekey(TV,SAT•CBL•DTC,DVD•VCR,

AUDIO, or AUX) whose code you wish to retrieve. The

POWER key illuminates. Keep pressing the device key.

2. While holding the device key down, press and hold the

INFO key. The POWER key illumination turns off. After

holding down both keys for three seconds, it turns back on.

3. Release both keys. The POWER key remains illuminated.

4. Starting with the number 1 key, press and release each

number key on the keypad in the following order: 1-9, then

0. The number that causes the POWER key to blink is the

ﬁrst number of the code. As you ﬁnd each number of the

code, write it down for future reference. Then start with the

number 1 key again.

5. Repeat step 4 until you have retrieved all ﬁve numbers in

the code. After the ﬁfth number is retrieved, the POWER

key blinks brieﬂy, then turns off.

Quick Code Reference

Device Type Code

Learning

Codes from the Code Lists include basic functionality for each

component they control. Once you have programmed in the

code for your speciﬁc component, you can customize the

universal remote to include certain functions from your original

remote(s) that were not embedded in the preset code. Your

universal remote has the ability to learn and store commands

from your original remote(s) under the mode(s) of your choice.

The universal remote can store up to 50 key commands.* Only

one original remote can be learned under any one mode (e.g.,

the universal remote can learn commands for one TV remote,

one VCR remote, etc.).

* Some learned signals require more memory than others. In

these cases, fewer key commands can be learned.

Before First-Time Learning

Before you start learning keys for the ﬁrst time, clear any

stored learning information that might be in the remote. This

lets you begin with a clean slate.

1. Press and hold the EXIT key (the POWER key illuminates).

While you’re holding down the EXIT key, use your other

hand to press and hold the POWER key (the POWER key

illumination turns off).

2. Wait until the POWER key comes on and stays on. Then

release both keys. The remote is now in the Master Clear

mode.

3. Press the OK key to conﬁrm the Clear operation. The

POWER key remains on for 2 seconds, then turns off. All

Learned functions for all components are now cleared; all

other programming remains intact.