NOTES
Throughout the programming of each key, keep the remote pointed at the IR sensor of the device you are programming the remote to control.
Test the remote with the device to make sure the device key is programmed with the correct code for maximum functionality. If some features don’t work, try a different code. See the “Testing the Code for Maximum Functionality” section below for more information.
During the Manual Code Search, the remote ignores keypresses that aren’t part of the search.
The search times out after two minutes (the POWER key blinks four times and the last programmed code under that device key is retained).
The POWER key blinks four times when the remote has gone through all the codes. The remote exits the Manual Code Search. If your device hasn’t turned off yet, try a different search method.
Testing the Code for Maximum Functionality
1.Try a variety of the device’s functions with the remote. If some features of your devices don’t work, go to the next step to try a different code.
2.Repeat the Manual Code Search and Entry Method from the beginning. When the device turns off for the first time, don’t press the OK key, which would store the same code. Instead, with the unit now off, continue to press the SKIP FWD key repeatedly until the unit turns back on.
3.Once the unit turns back on, you have found another code that operates the device. Press the OK key.
4.Test the key’s functionality again by trying a variety of functions. If the code controls the majority of the device’s functions, programming is complete. If the code stored does not give maximum functionality, try another code.
8
