Manual Code Search
The Manual Code Search takes you
TIPS: The Manual Code Search method may take a long time because the remote searches through all of the codes in its memory
To program the AUX key, you must first assign it to a device type. See the Assigning the AUX Key section.
Each device key is associated with a type of
To control combo devices, like TV/DVDs and TV/VCRs, you need to program each key separately. Each key will control that part of the combo device.
To exit without saving a new code at any point in the Manual Code Search, press the EXIT key.
1.Manually turn on the device you want to control.
2.Press and hold the device key you want to program (the POWER key illuminates). While you’re holding down the device key, use your other hand to press and hold the remote’s POWER key at the same time (the POWER key turns off).
3.Wait until the remote’s POWER key comes on and stays on. Then release both keys.
4.Point the remote directly at the front panel of the device you want to control. Press SKIP FWD on the remote and wait 2 seconds. The remote is testing a single code for your device.
Did your device turn off?
YES: Press the OK key to store the code. You’re done! You’ve programmed this device key.
NO: Press SKIP FWD again. The remote tests the next code for your device.
Keep pressing SKIP FWD every 2 seconds until your device turns off. When it does, press OK.
TIP: Because there are so many codes, you may have to press the SKIP FWD key many
English
7
