Analog recording

Setting the track numbers automatically

The level sync function is turned off during analog recording. Press the oREC button (or the remote controller RECobutton) and assign the track numbers automatically.

To have the track numbers assigned automatically by the CDR-205X, turn on the level sync function.

1 During recording or while in the

(23,m-11)recording standby state, press the

EDIT/NO button repeatedly until "Level Sync?" appears.

EDIT/NO

2 Press the YES button.

The current setting appears. The current setting is given on the left side (for the display given below, the current setting is "Off").

Note:

The level sync function uses the recording source level to detect the end and beginning of tracks. Therefore, in the cases given below, the track numbers may not be properly assigned.

•The recording on the cassette tape is poor (e.g., the space between songs contains much noise).

•With music such as classical music where there may be very low volumes.

•Where the space between songs is extremely short.

•If the signal at the tuner is weak (excessive noise).

•When recording from turntables.

To return to manual assignment of the track numbers

Set "Off" at step 2 (see page 27).

YES

3 Press the YES button.

The level sync function turns on. Press the EDIT/ NO button to return to the previous setting.

YES

Operations

25