Troubleshooting guide
If the
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to external noise or static electricity. If this happens, disconnect the power cord and then plug it in again after about 5 seconds.
About the
The
Display | Cause | Remedy |
Disc Error • Playback was likely stopped due to dirt, dust, scratches, or vibrations.
•The disc has been placed in upside down.
•Eject the disc and check for dirt, dust, and scratches (see page 16).
•Eject the disc and check that it is placed in correctly (see page 16).
If you place the disc correctly and the same message appears, unplug the power cord and plug it back in again. If the same message appears again, contact an Onkyo service representative.
Sys. Error | A malfunction has occurred in the system |
(flashing) | due to excessive noise or static electricity. |
Unplug the power cord and plug it back in again. If the same message appears again, contact an Onkyo service representative.
Messages during recording
Display | Cause | Remedy |
Cannot Copy The input digital signal contains a copy guard signal (SCMS).
Record an analog signal or recordable music signal (see page 48).
Cannot Rec | • | The digital input is blocked. | • | Verify that the player component is |
|
|
|
| properly playing and the digital cable is |
|
|
|
| properly connected. (see page 12). |
| • | Data has been input in the | • | Verify that source signal is a normal |
|
|
| music signal (see page 18). | |
Check Input | The player component was already | Stop the player component. Shortly thereafter, | ||
↓ ↑ | playing. | "Signal Wait" will appear (see page 28). | ||
Rec Setup
Rec Setup | The |
| recording standby state. |
Wait until the message disappears.
42