VIDEO SETUP
TV MODE
This setting allows the selection of interlaced (INTERLACE) or
`PROGRESSIVE:
For progressive scan TV: turn on the progressive scan mode.
`INTERLACE:
For ordinary TV: turn on the interlace mode.
•When your TV is not compatible with progressive scan, never select “PROGRESSIVE”. No picture will be shown on the monitor.
In case you select “PROGRESSIVE” by mistake, disconnect the connection of the unit and the TV, and then connect in again. And change the setting to “INTERLACE”.
COLOR SETTING
You can adjust some parameters of video picture.
Use e/rto select the parameter and change the value, then press ENTER.
■SHARPNESS
This adjusts the sharpness of the picture shown on the monitor.
`HIGH
`MEDIUM
`LOW
■BRIGHTNESS
This adjusts the brightness of the picture.
`-20 to +20
■CONTRAST
This adjusts the picture contrast.
`-16 to +10
■GAMMA
This adjusts the gamma value of the picture.
`HIGH
`MEDIUM
`LOW
`NONE
■HUE
This adjusts the green/red balance of the picture.
`-9 to +9
■SATURATION
This adjusts the saturation level.
`
■LUMA DELAY
This adjusts the luma delay.
`0 T
`1 T
HDMI SETUP
■HDMI
`AUTO:
Select this to have the signal output when your TV or monitor is connected to the HDMI OUT jack.
`OFF:
Select this when you do not use the HDMI OUT jack.
No signal is output from the HDMI OUT jack.
■RESOLUTION
You can specify the output resolution for the HDMI output.
`OFF
`480p 60Hz
`720p 60Hz
`1080i 60Hz
`1080p 60Hz
`576p 50Hz
`720p 50Hz
`1080i 50Hz
`1080p 50Hz
En
27
