Onkyo HT-R518 Advanced Setup-Continued, Speaker Levels, As each speaker outputs the test tone

HT-R518_En.book Page 62 Tuesday, March 11, 2008 11:31 AM

Advanced Setup—Continued

Speaker Levels

These settings are set automatically by the Automatic Speaker Setup function (see page 34).

You can set the volume level of each speaker so that all speakers can be heard equally at the listening position.

1	Press the [RECEIVER] REMOTE
	MODE button, followed by the
	[SETUP] button.

2 Use the Up and Down []/[ ] buttons to select “Level Cal,” and then press [ENTER].

A pink noise test tone is output by the front left speaker.

3	Turn up the volume so that you
	can hear the test tone suffi-
	ciently.
	As each speaker outputs the test tone,
	its name appears on the display.
4	Use the Left and Right [	]/[ ]
	buttons to adjust the speaker
	level, and use the Down [	] but-
	ton to select the next speaker.

The levels can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

5	Repeat step 4 so that the level of
	the test tone coming from each
	speaker is the same.
	Speakers that you set to No or None in
	the Speaker Configuration (page 59) do
	not output the test tone.

6	Press the [SETUP] button.
	Setup closes.
	Don’t forget to turn down the volume if
	you turned it up while setting the levels.

Note:

•The speaker levels cannot be adjusted while a pair of headphones is connected or the AV receiver is muted.

62