Onkyo HT-R518 Adjusting the Listening Modes, Using the Audio Adjust Settings, PLII/Neo6 Settings

HT-R518_En.book Page 55 Tuesday, March 11, 2008 11:31 AM

Adjusting the Listening Modes

Using the Audio Adjust Settings

With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.

1	Press the [RECEIVER] button fol-
	lowed by the [SETUP] button.

2	Use the Up and Down [ ]/[ ]
	buttons to select “6.Audio

Adjust,” and then press [ENTER].

3	Use the Left and Right [ ]/[ ]
	buttons to change the setting.

Press the Down [ ] button to select the next setting.

Repeat this step for the other settings.

4	Press the [SETUP] button.
	Setup closes.

The Audio Adjust settings are explained below.

Multiplex/Mono Settings

Multiplex

■Input (Mux)

This setting determines which channel of a stereo multi- plex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.

Main: The main channel is output (default). Sub: The sub channel is output.

M/S: Both the main and sub channels are out- put.

Mono

■Input (Mono)

This setting determines which channel is output when the Mono listening mode is used with a stereo source.

L+R: Both the left and right channels are output (default).

L:Only the left channel is output.

R:Only the right channel is output.

PLII/Neo:6 Settings

PLII Music (2 ch Input)

These settings apply to only 2-channel stereo sources.

These settings apply to Dolby Pro Logic II.

■Panorama

With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic II Music listening mode.

On: Panorama function on.

Off: Panorama function off (default).

■Dimension

With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic II Music listening mode. It can be adjusted from –3 to +3. The default value is 0. Higher settings move the sound field backward. Lower settings move it forward.

If the stereo image feels too wide, or there’s too much surround sound, move the sound field forward to improve the balance. Conversely, if the stereo image feels like it’s in mono, or there’s not enough surround sound, move it backward.

55