Controlling Other Components—Continued
Remote Control Codes for Onkyo Components Connected via
Onkyo components that are connected via are con- trolled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.
1 | Make sure the Onkyo component is con- | |||
| nected with an |
|
| cable and an analog |
|
| |||
|
|
| ||
| audio cable (RCA). |
| ||
| See page 32 for details. | |||
|
|
|
| |
2 | Enter the appropriate remote control code | |||
| to the REMOTE MODE button. |
•[DVD] REMOTE MODE button 31612: Onkyo DVD player with
•[CD] REMOTE MODE button 71327: Onkyo CD player with
•[TAPE] REMOTE MODE button
42157: Onkyo cassette recorder with (default)
•[DOCK] REMOTE MODE button
81993: Onkyo RI Dock with (default)
See the previous page for how to enter remote control codes.
3 Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.
If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via , use the following remote control codes:
•[DVD] REMOTE MODE button
30627: Onkyo DVD player without (default)
•[CD] REMOTE MODE button
71817: Onkyo CD player without (default)
•[DOCK] REMOTE MODE button 82990: Onkyo RI Dock without
Note:
•If you connect an
jacks, for to work properly, you must set the Input Display accordingly (see page 38).
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default remote control code.
1 | While holding down the REMOTE |
| |
| MODE button that you want to |
| reset, press and hold down the |
| [AUDIO] button until the Remote |
| indicator lights up (about 3 sec- |
| onds). |
(3 seconds)
2 | Within 30 seconds, press the |
| |
| REMOTE MODE button again. |
| The Remote indicator flashes twice, |
| indicating that the button has been |
| reset. |
| Each of the REMOTE MODE buttons |
| is preprogrammed with a remote con- |
| trol code. When a button is reset, its |
| preprogrammed code is restored. |
Resetting the Remote Controller
You can reset the remote controller to its default settings.
1 | While holding down the |
| |
| [RECEIVER] REMOTE MODE but- |
| ton, press and hold down the |
| [AUDIO] button until the Remote |
| indicator lights up (about 3 sec- |
| onds). |
(3 seconds)
2 | Within 30 seconds, press the |
| |
| [RECEIVER] REMOTE MODE but- |
| ton again. |
| The Remote indicator flashes twice, |
| indicating that the remote controller |
| has been reset. |
65