Remote Controller
The remote controller doesn’t work
•Make sure that the batteries are installed with the cor- rect polarity (page 12).
•Make sure that the remote controller is not too far away from the AV receiver and there’s no obstruction between the remote controller and the AV receiver’s remote control sensor (page 12).
•Make sure you’ve selected the correct remote control- ler mode.
•Make sure you’ve entered the correct remote control code (page 64).
Can’t control other components
•Make sure you’ve selected the correct remote control- ler mode.
•If you’ve connected an 
•The entered remote control code may not be correct. If more than one code is listed, try each one.
•With some AV components, certain buttons may not work as expected, and some may not work at all.
•To control an Onkyo component that’s connected via
, point the remote controller at the AV receiver. Be sure to enter the appropriate remote control code first (page 65).
•To control an Onkyo component that’s not connected
via 
, or another manufacturer’s component, point the remote controller at that component. Be sure to enter the appropriate remote control code first (page 64).
Recording
Can’t record
•On your recorder, make sure the correct input is selected.
•To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TAPE IN to TAPE OUT or VCR/DVR IN to VCR/DVR OUT).
•When the Pure Audio listening mode is selected, video recording is not possible because no video signals are output. Select another listening mode.
Others
The sound changes when I connect my head- phones
•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio, in which case it stays the same.
How do I change the language of a multiplex source
•On the “Audio Adjust” menu, change the “Input (Mux)” setting to Main or Sub (page 55).
The 
functions don’t work
•To use 
, you must make an 
connection and an analog audio connection (RCA) between the compo- nent and AV receiver, even if they are connected digi- tally (page 32).
The AV receiver’s display doesn’t work
•The display is turned off when the Pure Audio listen- ing mode is selected. Select another listening mode.
The following settings can be made for the
You must use the buttons on the unit to make these set- tings.
1.While holding down the input selector button for the input source that you want to set, press the [SETUP] button.
2. | Use the Left and Right [ ]/[ ] buttons to change |
| the setting. |
3. | Press the [SETUP] button when you’ve finished. |
• Video Attenuation
This setting can be made for the DVD, VCR/DVR, CBL/SAT, or AUX input.
If you have a games console connected to the
Video ATT:2: Gain is reduced by 2 dB.
The AV receiver contains a microcomputer for signal pro- cessing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall out- let, wait at least 5 seconds, and then plug it back in again.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by this unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.
Before disconnecting the power cord from the wall out- let, set the AV receiver to Standby.
75
