Advanced
Equalizer Settings
These settings are set automatically by the Automatic Speaker Setup function (see page 34).
Here you can adjust the tone of individual speakers. To set the volume of individual speakers, see page 62.
1 | Press the [RECEIVER] REMOTE |
| |
| MODE button, followed by the |
| [SETUP] button. |
2 | Use the Up and Down [ ]/[ ] |
| |
| buttons to select “Equalizer,” and |
| then press [ENTER]. |
3 | Use the Left and Right [ ]/[ ] |
| buttons to select: |
Off: Tone off, response flat. Audyssey: The tone for each speaker
is set automatically by the Automatic Speaker Setup function. Be sure to select this setting after having performed the Automatic Speaker Setup.
Manual: You can adjust the equal- izer for each speaker manually.
If you selected Manual, continue with this procedure. If you selected Off or Audyssey, go to step 7.
4 | Press the Down [ ] button, and |
| then use the Left and Right |
[]/[ ] buttons to select a speaker.
5 | Use the Up and Down [ | ]/[ | ] | |
| buttons to select a frequency. | |||
| Use the Left and Right [ | ]/[ | ] | |
| buttons to adjust the level at that | |||
| frequency. |
|
|
|
| The volume at each frequency can be | |||
| adjusted from |
| ||
| steps. |
|
|
|
| Tip: Low frequencies (e.g., 63Hz, |
| ||
| 80Hz) affect bass sounds; high frequen- | |||
| cies (e.g., 8000Hz, 16000Hz) affect tre- | |||
| ble sounds. |
|
|
|
6 | Use the Up [ | ] button to select | ||
| “Ch,” and then use the Left and | |||
| Right [ ]/[ | ] buttons to select | ||
| another speaker. |
|
|
Repeat steps 4 and 5 for each speaker. Speakers that you’ve set to No or None in the Speaker Configuration (page 59) cannot be selected.
7 | Press the [SETUP] button. |
| |
| The setup menu closes. |
Notes:
•The front, center, and surround speakers can be adjusted at 80Hz, 250Hz, 800Hz, 2500Hz, and 8000Hz. The subwoofer can be adjusted at 40Hz, 80Hz, and 160Hz.
•While the Direct or Pure Audio listening mode is selected, the equalizer settings have no effect.
•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.
63