Onkyo HT-R518 instruction manual Advanced Setup, Speaker Setup, Speaker Configuration

Cone diameter

HT-R518_En.book Page 59 Tuesday, March 11, 2008 11:31 AM

Advanced Setup

Speaker Setup

This section explains how to check the speaker settings and how to set them manually, which is useful if you change a speaker after performing the automatic speaker setup.

Some of the speaker settings are set automatically by the Automatic Speaker Setup function (see page 34).

For the HT-S5105 Home Theater System Cos- tomer

Speaker Configuration, Crossover Frequency, and Double Bass settings only need to be changed if you’re not using the speakers in this package.

These settings cannot be changed while head- phones are connected, speaker set B is on, or the multichannel DVD input is being used.

Speaker Configuration

These settings are set automatically by the Automatic Speaker Setup function (see page 34).

This section explains how to specify which speakers are connected and their sizes.

For speakers with a cone diameter

larger than 6-1/2 inches (16 cm), specify Large (full band). For those

with a smaller diameter, specify

Small (default crossover 100Hz). The crossover frequency can be

changed on page 60.

1	Press the [RECEIVER] button fol-
	lowed by the [SETUP] button.

2 Use the Up and Down []/[ ] buttons to select “Sp Config,” and then press the [ENTER] but- ton.

3

4

5

6

While the “Subwoofer” setting is selected, use the Left and Right []/[ ] buttons to select Yes or No.

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

Use the Down [ ] button to select “Front,” and then use the Left and Right []/[ ] buttons to select Small or Large.

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

Note:

•If the Subwoofer setting in step 3 is set to No, this setting is fixed at Large and does not appear.

Use the Down [ ] button to select “Center,” and then use the Left and Right []/[ ] buttons to select Small, Large, or None.

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

Use the Down [ ] button to select “Surround,” and then use the Left and Right []/[ ] but- tons to select Small, Large, or None.

Small: Select if the surround speak- ers are small.

Large: Select if the surround speak- ers are large.

None: Select if no surround speakers are connected.

59