Novatel user manual Chapter Installation and Setup, DL-V3 Setup

Chapter 2

Installation and Setup

This chapter contains instructions and tips to set up your DL-V3 to create a GNSS receiver system.

2.1Additional Equipment Required

In order for the receiver to perform optimally, the following additional equipment is required:

•A NovAtel GNSS antenna (user-supplied, NovAtel recommended)

•A quality coaxial cable, and interconnect adapter cable as necessary (user-supplied)

•A PC/laptop (user-supplied)

•A means of communicating between the DL-V3 and PC/laptop

•Serial null-modem cable (included with the receiver, NovAtel part number 01017658), see Figure 8, DB-9 Setup on Page 28

•USB cable (user-supplied), see Figure 9, USB Setup on Page 28

•Ethernet crossover cable (user-supplied), see Figure 11, Ethernet Setup on Page 29

•Bluetooth link (user-supplied), see Figure 10, Bluetooth Setup on Page 29

Use a serial COM or USB connection to communicate with the receiver first. This will give you the ability to configure the PC/laptop and DL-V3 before Ethernet or Bluetooth use.

•A power supply (user-supplied)

•A power cable (included with the receiver)

CAUTION: When the DL-V3 is installed in a permanent location, such as in a building, it should be protected by a lightning protection device according to local building codes. See also Warranty on Page 15.

2.1.1DL-V3 Setup

Complete the steps below to connect and power your DL-V3. See also Figures 8 to 11 starting on Page 28.

1.Mount a GNSS antenna on a secure, stable structure with an unobstructed view of the sky from horizon to horizon, see Section 2.1.7, Mounting the GNSS Antenna on Page 32.

2.Ensure a CF card is in the slot behind the door on the front face of the DL-V3. Open, or secure, the door by turning the latch. See also Section 2.2.6, DL-V3 Removable Compact Flash Memory Card starting on Page 39.

Once the CF card is installed, ensure that it is properly formatted, see Page 39.

DL-V3 User Manual Rev 3 25