Novatel DL-V3 user manual Groupinterfacemode Edit Group Interface Mode, 109

B.19 GROUPINTERFACEMODE Edit Group Interface Mode

The groupinterfacemode command allows you to edit the interface mode configuration for the group. The group can be configured to issue the interfacemode command to COM1, COM2 and/or AUX.

The groupinterfacemode set command sets the interface mode configuration for the group named groupname and port to the specified parameters (refer to the interfacemode command in the OEMV Family Firmware Reference Manual, for further details on rx_type, tx_type and responses). Port can be COM1, COM2 our AUX.

The groupinterfacemode clear and the groupinterfacemode default commands remove (disable) the interface mode configuration for all ports from the group named groupname.

Syntax

groupinterfacemode set groupname [port] [rx_type [tx_type]] [responses]

groupinterfacemode defaultclear groupname

B.19.1 Groupuse Translation

groupuse start

If set for the particular port, the interfacemode command is issued for the port.

groupuse stop

N/A

Message ID = 318

Field	Data	Value Used if	Bytes	Format	Units	Offset
		Not Specified
1	Header	-		-	-	0
2	Parameter Update, see Table 34 on	-	4	Enum	none	H
	Page 107
3	Group name	-	12	Char[]	none	H+4
4	Serial Port Identifier, see Appendix	NO_PORT	4	Enum	none	H+16
	C, Logs, Table 67 on Page 150
5	rx_type – Serial Port Interface	NOVATEL	4	Enum	none	H+20
	Mode, see Table 70 on Page 151
6	tx_type – Serial Port Interface Mode,	NOVATEL	4	Enum	none	H+24
	see Table 70 on Page 151
7	Responses	ON	4	Enum	none	H+28
	0 = Off
	1 = On

DL-V3 User Manual Rev 3 109