B.15 GROUPCOMVOUT Control COM Power for a Group

The groupcomvout command allows you to control the peripheral power supply on the COM ports when a specific group is executed. Command usage is similar to that of the comvout command, see Page 87, except that a group name argument is required.

1. The port specifier is the same for the groupinterfacemode command, see Page 109.

2.If you add GROUPCOMVOUT settings to a particular group, they do not take effect until the next time a GROUPUSE command is run for that group.

If added, each distinct group may have unique settings for GROUPCOMVOUT.

The groupcomvout set command enables you to configure comvout behavior for a specific group (when the group is executed). The interpretation of the groupcomvout arguments is the same as that seen for the comvout command.

The default action is supported for the groupcomvout command. If this argument is supplied, no changes to the current comvout configuration for a peripheral port occurs when the associated group is executed.

Example:

groupcomvout set mygroup com2 on groupcomvout set mygroup aux default

The groupcomvout clear command removes the comvout configuration for the specified port. The comvout configuration for that port is not altered when the group specified in groupname is executed.

The groupcomvout default command removes comvout configurations for all ports. The comvout configurations for all ports are not altered when the group specified in groupname is executed. This is equivalent to using the groupcomvout set command to specify default for every port.

Syntax

 

 

 

groupcomvout

set groupname

[com2 aux]

[on off default]

groupcomvout

clear default

groupname

[com2 aux]

B.15.1 Groupuse Translation

groupuse start

comvout settings for each configured port will be set. groupuse stop

N/A

DL-V3 User Manual Rev 3

103

Page 103
Image 103
Novatel DL-V3 user manual Groupcomvout Control COM Power for a Group, Example