Installation and Setup

Chapter 2

instructions, are available on the OEMV Family CD by selecting USB Support from the main menu. You can also check for updates to the drivers or release notes on our website at www.novatel.com.

CAUTION Do not connect USB ports if USB communications is not being used or you may risk damaging your receiver.

2.2.3Status Indicators

LED indicators on the DL-V3 provide the status of the receiver. They represent these categories:

Power

Receiver Status

COMs (COM1, COM2 and AUX)

COM3

Satellite Tracking

Flash Card Memory

Positioning Mode

Occupation Time

Power

The power indicator glows orange when the receiver is powered and then glows green once the receiver has been turned on. See also DL-V3 Power Down and the Power Button on Page 33.

Status

The status indicator flashes orange when the receiver is first turned on. Under normal operation, this LED is off. If a status event occurs, the LED flashes orange again. See also to the chapter on Built-In Status Tests in the OEMV Family Installation and Operation User Manual and the RXSTATUS log in the OEMV Family Firmware Reference Manual.

Communication Ports (excluding COM3)

The top of the COM1, COM2 and AUX LEDs flash GREEN when transmitting data while the bottom of them flash AMBER when receiving data.

COM3

The COM3 section of the LED panel on the front of the DL-V3, has two LEDs:

• 1 for Bluetooth Mode

• 1 for Ethernet Mode

Only one mode may be used at a time on COM3. The active mode’s LED flashes blue for Bluetooth and glows orange for Ethernet. If the receiver is turned off, or power is removed, the Ethernet or Bluetooth mode on COM3 is returned to whichever mode was applied before power-down when it is powered up again. See also Appendix D, Ethernet Configuration starting on Page 178.

DL-V3 User Manual Rev 3

35

Page 35
Image 35
Novatel DL-V3 user manual Status Indicators, Power, Status Communication Ports excluding COM3