Table 83: HyperTerminal Default Parameters

Parameter

Setting

BAUD

9600

 

 

DATA BITS

8

 

 

PARITY

N

 

 

STOP BITS

1

 

 

FLOW CONTROL

NONE

 

 

ASCII SETTINGS

Disable echo typed characters locally

 

 

COM1 is used to tunnel to COM3 to gain direct access to the Ethernet.

COM2 is used to issue NovAtel commands to the DL-V3 using HyperTerminal communications software. The communications parameters should be set to the defaults for DL-V3 COM2. Typically, 9600, 8, N, 1, no parity and local echo on.

D.3.3 DL-V3 Commands

D.3.3.1 Switch to Ethernet Device

Once communication has been established between your laptop serial port (or USB port with a USB- to-serial port adaptor) and COM2 on the DL-V3, enter the following commands:

• LOG VERSION

see Page 177

Record the OEMV-3 part serial number (PSN) for future use (associated with the Ethernet Media Access Control (MAC) address).

• APPCONTROL BLUETOOTH 1

see Pages 85-86

Switch COM3 peripheral to Ethernet. On the front of the DL-V3, the Bluetooth LED no longer glows blue but instead the Ethernet LED glows orange.

• LOG COMCONFIG

refer to the OEMV Firmware Reference Manual

COMCONFIG shows you the current port settings (the default baud setting for COM3 is 115200). The COM commands below ensure both COM1 and COM3 are set to 9600 baud.

• COM COM1 9600 N 8 1

refer to the OEMV Firmware Reference Manual

COM COM3 9600 N 8 1

LOG COMCONFIG

The COMCONFIG command should verify that COM3 is now set to 9600 baud.

DL-V3 User Manual Rev 3

189

Page 189
Image 189
Novatel DL-V3 user manual HyperTerminal Default Parameters, Switch to Ethernet Device