Novatel DL-V3 user manual Appendix D, Physical Set-Up

Appendix D

Ethernet Configuration

This section details the ethernet configuration for the DL-V3 including automatic Ethernet configuration on start-up.

On power-up, or after a FRESET command, the DL-V3 automatically configures the Ethernet device. This configuration includes the following settings:

•Static IP address: 192.168.1.223

•Subnet mask: 255.255.255.0

•Ethernet Line 1 speed: 115 200 bps

If the receiver is turned off, or power is removed, the Ethernet or Bluetooth mode on COM3 is returned to whichever mode was applied before power-down when it is powered up again. When you issue a FRESET command, COM3 defaults to Bluetooth mode.

D.1 Physical Set-Up

Below are the configuration methods described in this section and the hardware you require to set them up:

•Configuration Via Network Cable

-DL-V3 with power cable and serial communications cable

-User-supplied laptop with an available Ethernet port, serial port (or USB port with NovAtel serial to USB drivers) and the Lantronix software, described below, installed

-Sheilded CAT5 Ethernet cross-over cable (or use a switch with a straight through Ethernet cable)

•Configuration Via Serial and Network Parameters

-DL-V3 with power cable

-User-supplied laptop with the Lantronix software, described below, installed

-Serial null-modem cable to connect from the laptop and switch between COM1 and COM2 on the DL-V3. You can avoid switching if you have two serial connections on your laptop and two null-modem cables. Also, if your laptop has only USB connectors, you need a USB to serial adaptor between the null-modem cable and the laptop’s USB connector.

-Sheilded CAT5 Ethernet cross-over cable (or use a switch with a straight through Ethernet cable)

In both cases, first install the Com Port Redirector (CPR) Manager program onto the laptop you intend to use with your DL-V3 from the Lantronix website at: http://www.lantronix.com/device- networking/utilities-tools/.

Figure 39 below shows the two methods of physically providing an Ethernet connection between your laptop and DL-V3. The top shows a direct connection using a sheilded CAT5 Ethernet cross-over cable and the bottom shows two straight-through sheilded CAT5 Ethernet cables with a DSS-5+ port

178 DL-V3 User Manual Rev 3