Chapter 1

Introduction

The DL-V3 is a high-performance GNSS receiver capable of receiving and tracking different combinations of GPS L1 C/A, L2C, L2 P(Y) and L5 code and carrier, GLONASS L1 and L2 code and carrier, and L-Band (CDGPS and OmniSTAR) on a maximum of 72 channels. SBAS support is standard and the DL-V3 adaptability offers multi-system, frequency, and size configurations for any application requirement. Refer to the GNSS Reference Book for an overview of each of the above signal types, available from our website at http://www.novatel.com/support/docupdates.htm. The DL- V3’s front panel also features light emitting diodes (LEDs) for on the fly observations.

The DL-V3 is a triple-frequency GNSS receiver with integrated L-band capability but without the need for a separate board. It is GLONASS-enabled with measurements, full code and RTK positioning.

Once you connect the DL-V3 to an antenna and power supply, it begins operating as a fully functional GNSS system. Figure 2 below shows the DL-V3 without an antenna or connecting cables.

Figure 2: DL-V3 Receiver

1.1Models and Features

The DL-V3 is available in several different firmware models whose configurations may include other additional features. Some possible configurations can be seen in Table 1.

Table 1: DL-V3 Controller Models

Model Name

Firmware Feature

DL-V3-L1

L1-only

 

 

DL-V3-L1L2

L1/L2

 

 

DL-V3-RT20

L1 plus RT-20

 

 

DL-V3-RT2

L1/L2 plus RT-2

 

 

DL-V3-VBS

L1 plus OmniSTAR VBS, and CDGPS

 

 

DL-V3-HP

L1/L2 plus OmniSTAR HP/XP/VBS, and

 

CDGPS

 

 

DL-V3 User Manual Rev 3

23

Page 23
Image 23
Novatel user manual Chapter Introduction, DL-V3 Controller Models, Model Name Firmware Feature