Novatel DL-V3 user manual Freset Clear Selected Data from NVM and Reset, Freset Target

B.9 FRESET Clear Selected Data from NVM and Reset

The OEMV freset command is extended to include DL-V3 features. An additional target field, userdata (value = 10), resets only the DL-V3 user data NVM, thereby resetting all parameters indicated in this document as “Stored in NVM” to factory defaults. Issuing the freset command with the “target” field set to standard, resets the userdata NVM as well as OEMV parameters as indicated in the OEMV Family Firmware Reference Manual.

The DL-V3 factory default command list is on Page 96.

If you issue the FRESET command without any parameters, it is the same as issuing a FRESET STANDARD command.

	Fiel	Field			ASCII	Binar			Binary	Binar	Binar
						y		Description	Forma	y	y
	d	Type			Value
						Value			t	Bytes	Offset
1		FRESET			-	-		This field contains the command name	-	H	0
		header						or the message header depending on
								whether the command is abbreviated
								ASCII, ASCII or binary, respectively.
2		target			See Table 24			Data to be reset by the receiver	Enum	4	H
								Table 24: FRESET Target
	Binary			ASCII				Description
	0		STANDARD				Resets commands, ephemeris, and almanac (default). Also resets all L-
							band related data except for subscription information.
	1		COMMAND				Resets the stored commands (saved configuration)
	2		GPSALMANAC				Resets the stored GPS almanac
	3		GPSEPHEM				Resets the stored GPS ephemeris
	4		GLOEPHEM				Resets the stored GLONASS ephemeris
	5		MODEL				Resets the currently selected model
	10		USERDATA				Reset DL-V3-only commands
	11		CLKCALIBRATION				Resets the parameters entered using the CLOCKCALIBRATE command
	20		SBASALMANAC				Resets the stored SBAS almanac
	21		LAST_POSITION				Resets the position using the last stored position
	31		GLOALMANAC				Resets the stored GLONASS almanac

94 DL-V3 User Manual Rev 3