Novatel DL-V3 user manual Syntax Conventions

Message ID	ASCII Command	Description
257	write	Create logs containing user data
271	groupdgpstxid	Edit the DGPS base ID configuration for the group
284	disk	Carry out CF card maintenance
318	groupinterfacemode	Edit the interface mode configuration for the group
753	groupcomvout	Control power on specified COM ports for the group
755	groupcom	Associate one or more port configurations with a group
779	comvout	Control the peripheral power supply on specific COM ports
781	appcontrol	Switch between Ethernet and Bluetooth on COM3

The arguments for each of these commands are described in the following sections.

For a complete listing and description of the other commands that the DL-V3 is capable of processing, please refer to the OEMV Family Firmware Reference Manual.

B.1 SYNTAX CONVENTIONS

The following rules apply when entering commands, at the command prompt, from a keyboard.

1.Courier font is used to illustrate program output or user input.

2.References to other commands, logs or any of their fields are shown in italics.

3.The commands are not case sensitive. For example, you could type either METTEMP 0 or mettemp 0.

4.Except where noted, either a space or a comma can separate commands and their required entries. For example, you could type either group del alpha p20a or group,del,alpha,p20a.

5.At the end of a command, a carriage return is required. For example, press <Enter> or <Return> on your keyboard.

6.Responses are provided to indicate whether or not an entered command was accepted. The format of the response depends on the format of the command. Refer to the OEMV Family Firmware Reference Manual for more information.

7.Optional parameters are indicated by square brackets ( [ ] ). For commands that contain optional parameters, the value used if the optional parameter is not specified is given in the syntax table for the command.

8.Data format definitions, as specified in the “Format” field, are detailed in the OEMV Family Firmware Reference Manual. Note that all binary data is little-endian byte-ordered.

84 DL-V3 User Manual Rev 3