Novatel DL-V3 user manual Chapter Installation and Setup, Antenna Port

Chapter 2 Installation and Setup

3.Use a coaxial cable to connect the antenna to the SAT ANT port, see Figure 3 below, which is found on the back face of the DL-V3. See also Section 2.1.8, Connecting the Antenna to the Receiver on Page 32.

Figure 3: Antenna Port

4.Establish a physical communication connection between the DL-V3 and the PC/laptop

Either:	Connect COM1 on back of the DL-V3, see Figure 4 below, to a DB-9 serial
	port on the PC/laptop
or:	Connect the USB port, see Figure 4, on the front of the DL-V3 to a USB port
	on the PC/laptop (first install the USB drivers available on the CD provided),
	see also Section 2.2.2, Universal Serial Bus (USB) starting on Page 34

Figure 4: COM1 Port (left) and USB Port (right)

The following types of connection can be made after initial communication and configuration steps have been taken for either Bluetooth or Ethernet:

Either:	Connect the Ethernet port, see Figure 5 on Page 27, on the back of the DL-V3
	to an Ethernet port on the PC/laptop. See also Appendix D, Ethernet
	Configuration starting on Page 178
or:	Use Bluetooth communications, see Figure 6 on Page 27. See also Appendix E,
	Bluetooth Configuration starting on Page 195

See also Section 2.1.10, Connecting Data Communications Equipment on Page 33.

26 DL-V3 User Manual Rev 3