Novatel DL-V3 user manual Appcontrol COM3 Bluetooth/Ethernet Switch, Dhcp OFF

B.2 APPCONTROL COM3 Bluetooth/Ethernet Switch

Use the appcontrol command to switch between Ethernet and Bluetooth on COM3.

Use the appcontrol option 12 9 command to restore Ethernet settings back to their defaults1:

IP: 192.168.1.223

Mask: 255.255.255.0

DHCP: OFF

The APPCONTROL OPTION 12 9 command triggers a receiver RESET and, on startup, restores the Ethernet defaults.

The APPCONTROL OPTION 12 1 command resets the XPORT-AR Ethernet device. This does not restore the Ethernet defaults. The Ethernet device settings are persistent until you issue a FRESET or APPCONTROL OPTION 12 9 command, see above.

When COM3 uses Bluetooth, the baud rate is set to 115200. When COM3 is switched to Ethernet, the baud rate is still 115200.

1. When the DL-V3 is in Bluetooth range, your computer can recognize it and is able to access it using this password: 0000 (four zeroes).

2.If the receiver is turned off, or power is removed, the Ethernet or Bluetooth mode on COM3 is returned to whichever mode was applied before power-down when it is powered up again.

Syntax

appcontrol function param1 [param2 [param3 [param4]]]

Message ID = 781

Field	Data	Value Used if	Bytes	Format	Units	Offset
		Not Specified
1	Header	-		-	-	0
2	Application control function	BLUETOOTH	4	Enum	none	H
3	Application control parameter 1, see Table 16	0	4	Enum	none	H+4
	and the examples that follow
4	Application control parameter 2 (for future use)	0	4	Ulong	none	H+8
5	Application control parameter 3 (for future use)	0	4	Ulong	none	H+12
6	Application control parameter 4 (for future use)	0	4	Ulong	none	H+16

1.See also the Ethernet Configuration appendix starting on Page 178.

DL-V3 User Manual Rev 3 85