Novatel DL-V3 user manual Metpress Specify Air Pressure, Metpress Default Configuration

B.30 METPRESS Specify Air Pressure

The metpress command allows you to specify air pressure. Air pressure specified with the metpress command does not affect receiver operation. Rather, it allows you to create a record of atmospheric conditions for post-processing purposes.

The metpress set command specifies air pressure at press. This command only stores the pressure value in volatile memory, and does not automatically generate a record. The humidity value can then be displayed/recorded by requesting the met log.

The metpress clear and the metpress default commands clear the air pressure setting.

Syntax

metpress set [press] metpress defaultclear

Message ID = 164

	Field	Data	Value Used if	Bytes	Format	Units	Offset
			Not Specified
1		Header	-		-	-	0
2		Parameter Update, see	-	4	Enum	none	H
		Table 34 on Page 107
3		Pressure (in hectopascals or	0	4	Float	kPa or	H+4
		kilopascals where:				hPaa
		1 kPa = 10 hPa)

a.You may use hPa or kPa in your float input depending on your preference

Table 50: METPRESS Default Configuration

Parameter	Power-On	Freset	Stored in NVM
metpress	clear	clear	NO

128 DL-V3 User Manual Rev 3