Novatel DL-V3 user manual Network Configuration in Command Mode, 192

D.3.4 Network Configuration in Command Mode

1. Text within brackets < > denote optional parameters.

2.An IP address must be formatted in dotted quad IP address notation and be valid for the network. An example of dotted quad notation is: 192.168.0.254

3.Refer to the Lantronix XPORT-AR User Guide for a full command set. Lantronix website details are on Section D.1, Physical Set-Upon Page 178.

11.(continued from Page 191) Enter the following Ethernet command-mode commands on COM1, to configure the network settings:

•show

1. Record the MAC address. It should appear as a set of six hexadecimal value pairs separated by colons. For example:

00:20:4A:44:55:66

2.The show command is not shown in Figure 42 on Page 191.

•configure

•if 1

•ip address <IP> <network mask>

•ip default-gateway <gateway IP address>

•no dhcp

•speed auto

•exit

•exit

•write

•line 1

•databits 8

•flowcontrol hardware

•speed 115200

12.Change the baud rates to re-establish communications with the Ethernet device now that the Ethernet is set to 115200, but the tunneled serial ports on the DL-V3 are still at 9600 baud. In addition, HyperTerminal’s baud rate is also still set to 9600.

192 DL-V3 User Manual Rev 3