
Connecting the AV Receiver—Continued
Speaker Connection Precautions
Read the following before connecting your speakers:
•North American/Taiwan models: You can connect speakers with an impedance of between 6 and 16 ohms. If you use speakers with a lower impedance, and use the amplifier at high volume levels for a long period of time, the
•Other models: You can connect speakers with an impedance of between 4 and 16 ohms. If the imped- ance of any of the connected speakers is 4 ohms or more, but less than 6 ohms, be sure to set the minimum speaker impedance to “4ohms” (see page 43). If you use speakers with a lower impedance, and use the amplifier at high volume levels for a long period of time, the
•Disconnect the power cord from the wall outlet before making any connections.
•Read the instructions supplied with your speakers.
•Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals only to positive
(+) terminals, and negative
•Unnecessarily long, or very thin speaker cables may affect the sound quality and should be avoided.
•If you use 4 or 5 speakers, connect each of the two surround speakers to the SURR L/R terminals. Do not connect them to the SURR BACK L/R or FRONT HIGH L/R terminals.
•Be careful not to short the
positive and negative wires.
Doing so may damage the AV receiver.
• Make sure the metal core of the wire does not have contact with the AV receiver’s rear
panel. Doing so may damage the AV receiver.
•Don’t connect more than one cable to each speaker terminal. Doing so may damage the AV receiver.
•Don’t connect one speaker to several terminals.
Connecting the Speaker Cables
1 | Strip | |
| 15 mm) of insulation |
|
| from the ends of the |
|
| speaker cables, and |
|
| twist the bare wires |
|
| tightly, as shown. |
|
2 | Unscrew the terminal. |
|
3 | Fully insert the bare |
|
| wires. |
|
4 | Screw the terminal tight. | |
FRONT HIGH L/R, ZONE 2 L/R (North American/Taiwan models)
1 | Strip | |
| 12 mm) of insulation |
|
| from the ends of the |
|
| speaker cables, and |
|
| twist the bare wires |
|
| tightly, as shown. |
|
2 | While pressing the lever, | |
| insert the wire into the |
|
hole, and then release the lever. Make sure that the
terminals are gripping the bare wires, not the insulation.
17