Onkyo SR607 instruction manual Advanced Setup, Common Procedures in Setup Menu, Speaker Setup

Advanced Setup—Continued

Common Procedures in Setup Menu

RECEIVER

qwer

ENTER

SETUP

1	Press the [RECEIVER] button followed by
	the [SETUP] button.
	The main menu appears onscreen.
	If the main menu doesn’t appear, make sure the
	appropriate external input is selected on your TV.
2	Use the Up and Down [q]/[w] buttons to
	select main menu, and then press
	[ENTER].
3	Use the Up and Down [q]/[w] buttons to
	select the function, and then press
	[ENTER].
4	Use the Up and Down [q]/[w] buttons to
	select setting, and then use the Left and
	Right [e]/[r] buttons to set them.
5	When you’ve finished, press the [SETUP]
	button.

The setup menu closes.

Speaker Setup

Some of the settings in this section are set automatically by the Audyssey 2EQ™ Room Correction and Speaker Setup function (see page 46).

Here you can check the settings made by the Audyssey 2EQ Room Correction and Speaker Setup function, or set them manually, which is useful if you change one of the connected speakers after using the Audyssey 2EQ Room Correction and Speaker Setup function.

Note:

The Speaker Setup cannot be carried out while headphones are connected to the AV receiver.

Speaker Settings

See “Speaker Settings” on page 43

Speaker Configuration

With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. Specify “Full Band” for speakers that can output low frequency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be output by the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover frequencies.

Subwoofer	Yes: Select if a subwoofer is connected (default).
	No: Select if no subwoofer is connected.
Front*1	Full Band, 40Hz to 100Hz (default), 120Hz, 150Hz, 200Hz
Center*2	Full Band, 40Hz to 100Hz, 120Hz, 150Hz, 200Hz
Surround*2	None: Select if no speaker is connected.
Front High*3*4*5*6
Surr Back*3*4*5*7
Surr Back CH*8	1ch: Select if only one surround back L speaker is connected.
	2ch: Select if two (left and right) surround back speakers are connected (default).

70