Onkyo SR607 instruction manual LPF of LFE, Double Bass*9, Speaker Distance, Unit Feet, Meters

Advanced Setup—Continued

LPF of LFE 80Hz, 90Hz, 100Hz (default), 120Hz

(Low-Pass Filter for the LFE Channel)

This setting is not set automatically by the Audyssey 2EQ™ Room Correction and Speaker Setup function (see page 46).

With this setting, you can specify the cutoff frequency of the LFE channel’s low-pass filter (LPF), which can be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel.

Double Bass*9

This setting is not set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 46).

With the Double Bass function, you can boost bass output by feeding bass sounds from the front left and right channels to the subwoofer.

On: Double Bass function on. Bass from the front left and right channels is also fed to the subwoofer (default).

Off: Double Bass function off.

Notes:

*1 If the “Subwoofer” setting is set to “No”, the “Front” setting is fixed at “Full Band”.

*2 If the “Front” setting is set to anything other than “Full Band”, “Full Band” cannot be selected here.

*3 If the “Surround” setting is set to “None”, this setting cannot be selected.

*4 If the “Surround” setting is set to anything other than “Full Band”, “Full Band” cannot be selected here.

*5 If the “Speaker Type” setting is set to “Bi-Amp” (page 43), or Powered Zone 2 is being used (page 86), this setting cannot be selected.

*6 If the “SurrBack/FrontHigh” setting is set to “SurrBack” (page 43), this setting cannot be selected.

*7 If the “SurrBack/FrontHigh” setting is set to “FrontHigh” (page 43), this setting cannot be selected.

*8 If the “Surr Back” Setting is set to “None” (page 70), this setting cannot be selected.

*9 This function can be set only if the “Subwoofer” setting is set to “Yes”, and the “Front” setting is set to “Full Band”.

Speaker Distance

This setting is set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 46). Here you can specify the distance from each speaker to the listening position so that the sound from each speaker arrives at the listener’s ears as the sound designer intended.

Unit	feet:	Distances can be set in feet. Range: 1 to 30 feet in 1-foot steps.
	meters:	Distances can be set in meters. Range: 0.3 to 9 meters in 0.3-meter steps.

Left, Front High left, Center, Front High Right, Right, Surr Right, Surr Back R,

Surr Back L, Surr Left, Subwoofer

Specify the distance from the each speaker to your listening position.

Note:

Speakers that you set to “No” or “None” in the Speaker Configuration (page 70) cannot be selected.

Notes:

•The Center and Subwoofer distances can be set up to 5 ft. (1.5 m) more or less than the Left distance. For example, if the Left distance is set to 20 ft. (6 m), the Center and Subwoofer distances can be set between 15 and 25 ft. (4.5 and 7.5 m).

•The Surround distances can be set up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the Left distance. For example, if the Left distance is set to 20 ft. (6 m), the SurrRight and Surr Left distances can be set between 5 and 25 ft. (1.5 and 7.5 m).

71