Onkyo SR607 instruction manual Using Audyssey 2EQ, Turn on the AV receiver and the connected TV

First Time Setup—Continued

Using Audyssey 2EQ™ 1

STANDBY/ON

2

Speaker setup microphone

	qwer
ENTER	3

Notes:

•If any of your speakers is 4 ohms, change the “Speaker Impedance” setting before running the Audyssey 2EQ Room Correction and Speaker Setup (see page 43).

•If the AV receiver is muted, it will be unmuted automatically when the Audyssey 2EQ Room Correction and Speaker Setup starts.

•Room correction and speaker setup cannot be performed while a pair of headphones is connected.

•It takes about 15 minutes to complete the room correction and speaker setup for three positions. Total measurement time varies depending on the number of speakers.

•Do not disconnect the speaker setup microphone during the room correction and speaker setup, unless you want to cancel the setup.

•Do not connect or disconnect any speakers during the room correction and speaker setup.

The onscreen setup menus appear only on a TV that is connected to the HDMI OUT. If your TV is connected to the MONITOR OUT V or the COMPONENT VIDEO OUT, use the AV receiver’s display when changing settings.

Turn on the AV receiver and the connected TV.

On the TV, select the input to which the AV receiver is connected.

Set the speaker setup micro- phone at the Main Listening Posi- tion 1 (page 46), and connect it to the SETUP MIC jack.

The speaker setting menu appears.

2EQ: Auto Setup
Speaker Type	Normal
Powered Zone 2	Not Act
Surr Back/Front High	Surr Back
	Enter : Next

If you change these settings, refer to step 5 on “Speaker Settings” (page 43) or step 4 on “Setting the Powered Zone 2” (page 86).

When you’ve finished, press the [ENTER] button.

2EQ: Auto Setup

Please place setup microphone at center of listening area at ear height.

Next

Notes:

•Before starting Audyssey 2EQ™ Room Correction and Speaker Setup, arrange the room and connect the speakers as you would for enjoying movies. Changes to the room after auto setup requires you run the auto setup again, as room EQ characteristics may have changed.

•When starting the room correction and speaker setup, do not stand between the speakers and microphone, and avoid obstacles blocking the path between speakers and microphone. This will produce inaccurate results.

•Position the microphone at ear height of a seated listener with the microphone tip pointed directly at the ceiling using a tripod. Do not hold the microphone in your hand during measurements as this will produce innacurate results.

47