(Installing the FLEXnet DC continued)

Insert the 10-pin connector to the wiring block on the back of the FLEXnet DC.

Install the CAT5 cable into the RJ45 jack in the back

of the FLEXNet DC. Connect the other end of the

cable to the HUB using Port #2 or higher.

FLEXnet DC removed from the breaker bracket for clarity.

Replace the breaker bracket and secure with its four corner fasteners.

With all FLEXnet DC wires connected, reinstall the DC enclosure cover and secure its four Phillips screws.

After the cover is installed, reconnect the battery cables at the battery, turn on all the breakers, and power up the system.

10

Page 11
Image 11
Outback Power Systems manual Installing the FLEXnet DC