PG2 Reset CLR Main | Outback Power Systems DC guide

ADV/DC/PAGE 2-----------------

choose category:

PG1 CHARGE AUX PG3

ADV/DC/AUX/PAGE 3----------

choose category:

PG2 RESET CLR MAIN

Press the <PG3> soft key.

Pressing the <RESET> soft key resets the FLEXnet DC to its factory default settings.

Pressing the <CLR> soft key clears the data log memory.

28

Image 29

Outback Power Systems DC manual PG2 Reset CLR Main

Contents

NetTM DC FLEXnet DC User’s Guide 2007 All rights reserved WarrantyAbout OutBack Power Systems Date and Revision DisclaimerContact Information January Table of Contents Introduction OutBack Power Systems FLEXnet DC System Overview Reading the FLEXnet DC Postion wiring block FLEXNet DC package includes Installing the FLEXnet DC Connect each twisted pair to a shunt White to BAT Black to BAT + Wiring Block ConnectionsTorque Values Installing the FLEXnet DC FLEXNet DC Measurements Maximum battery voltageKiloWatts Maximum amp charged Data Logging User Adjustable Set PointsLogged Data Programming and Using the Mate for FLEXNet DC Operations FLEXNet DC Modes All unused channels should be set to disabledCharge Cycle Typical charge cycle Green Yellow RED Programming the Auxiliary Relay Auto ModeRelay Logic Invert Logic Hi Set Point Satisfied Mate Screens Readings Press the DC soft key to view the status of the FlexNet DC Down Status STATUS/FN Stats Meter Shunt Batt TOP STATUS/DC/SHUNT a Down UP Reset Down UP Reset TOP STATUS/DC/BATT UP TOP Status ADV BAT Shunt PG2 Press the ADV soft key Press the DC soft key Press the Charge soft key PG1 Charge AUX PG3 ADV/DC/AUX Control ADV/DC/AUX SOC LOW PG2 Reset CLR Main Technical Notes Battery Charge Factor BCF FLEXnet Products Year Limited Warranty Revision.2007-08-29 Outback Power Systems Inc 19009 62nd Ave. NE Limited Warranty Registration REV B