Insert the FLEXNet DC inside the DC breaker box and through the back side of the breaker bracket; secure with two #6-32 X 3/8 panhead machine screws (included) torqued at 5 to 8 inch-pounds

Connect all wires to the ten-pin wiring connector. Do not leave any loose wires!

Connect each twisted pair to a shunt.

Source/Load Negative

Battery Negative

Example:

Battery side (green wire in twisted pair) connects to the battery negative side of the shunt

Device side (white wire in twisted pair) connects to the source/load (negative) side of the shunt

NOTE: Color of wiring jacket can vary

NOTE: The FLEXNet DC shunts must be connected in the negative (low) side of whatever they monitor. Otherwise, the unit can be damaged.

8

Page 9
Image 9
Outback Power Systems DC manual Connect each twisted pair to a shunt