Table of Contents | Outback Power Systems DC guide

TABLE OF CONTENTS

Warranty Summary	1
Introduction	4
System Overview	5
Reading the FLEXnet DC	6
FLEXnet DC Package	7
Installing the FLEXnet DC	7-10
FLEXnet DC Measurements	11
Logged Data	12
User Adjustable Set Points	12
Programming and Using the MATE for FLEXnet Operations	13
FLEXnet DC Modes	14
Programming the Auxiliary Relay	16
MATE Screens	17-28
Technical Notes	29
Warranty	30-31
Warrranty Registration	32

3

Image 4

Outback Power Systems DC manual Table of Contents

Contents

NetTM DC About OutBack Power Systems WarrantyFLEXnet DC User’s Guide 2007 All rights reserved Disclaimer Date and RevisionContact Information January Table of Contents OutBack Power Systems FLEXnet DC Introduction System Overview Postion wiring block Reading the FLEXnet DC Installing the FLEXnet DC FLEXNet DC package includes Connect each twisted pair to a shunt Torque Values Wiring Block ConnectionsWhite to BAT Black to BAT + Installing the FLEXnet DC Maximum battery voltage FLEXNet DC MeasurementsKiloWatts Maximum amp charged Logged Data User Adjustable Set PointsData Logging Programming and Using the Mate for FLEXNet DC Operations All unused channels should be set to disabled FLEXNet DC ModesCharge Cycle Typical charge cycle Green Yellow RED Auto Mode Programming the Auxiliary RelayRelay Logic Invert Logic Hi Set Point Satisfied Mate Screens Press the DC soft key to view the status of the FlexNet DC Readings Down Status STATUS/FN Stats Meter Shunt Batt TOP STATUS/DC/SHUNT a Down UP Reset Down UP Reset TOP STATUS/DC/BATT UP TOP Status ADV BAT Shunt PG2 Press the Charge soft key Press the ADV soft key Press the DC soft key PG1 Charge AUX PG3 ADV/DC/AUX Control ADV/DC/AUX SOC LOW PG2 Reset CLR Main Battery Charge Factor BCF Technical Notes Year Limited Warranty FLEXnet Products Revision.2007-08-29 Limited Warranty Registration Outback Power Systems Inc 19009 62nd Ave. NE REV B