Outback Power Systems FW-SP-ACA manual FW-SP-R Replacement for the FW-SP-250

FW-SP-R (REPLACEMENT) for the FW-SP-250

In the event an FW-SP-250’s board is damaged, it can be replaced without going to the expense of

replacing the cover as well.

Tools Required to Install:		Purpose:
•	Slotted screwdriver	•	Wiring to the AC wiring block
•	Phillips screwdriver	•	Remove and install covers
• 13 mm socket (torque ratchet)		• Securing wires to FX DC terminals

Procedure: Be sure all AC and DC power to the FX is shut off before installing the FW-SP-250.

(3)Remove the FW-SP-250 (secured by six Phillips screws).

(2)Remove the AC Wiring Compartment cover (secured by two Phillips screws).

(1)Remove the DCC or Turbo cover (secured by four Phillips screws) and the DC battery caps.

(4)Remove the damaged FLEXware Surge Protector by unfastening these four Philips screws.

(5)The new FW-SP-R installs on these four standoffs on the inside of the FW-SP-250 cover; torque to 8-12 inch- pounds.

(6)When the new surge protector board has been secured to the FW-SP-250 cover, reinstall the FW-SP-250 as shown on pages 10-11.

15