Manuals / Outback Power Systems / Computer Equipment / Surge Protector

Outback Power Systems FW-SP-R, FW-SP-250, FW-SP-ACA manual Remove these Two M5 hex bolts from the FX

Models: FW-SP-ACA FW-SP-R FW-SP-250

1 22

Download 22 pages 12.25 Kb

Page 8

Image 8

(3)Remove the AC Wiring Compartment plastic cover (secured with two Phillips screws)

(4)Remove these

two M5 hex bolts from the FX

(5)Remove the AC Con- duit Plate, which slides up and out from the FX

(2)Remove the DC battery caps (under the DCC or Turbo)

(1)Remove the DCC or Turbo (secured by four Phillips corner screws)

Figure 5: Removing various covers from the FX

7

Image 8

Outback Power Systems FW-SP-R, FW-SP-250 Remove these Two M5 hex bolts from the FX, Removing various covers from the FX

Contents

Includes Mounting and Installation Surge Protector Contact Information About OutBack Power SystemsDisclaimer Warranty Introduction Dear OutBack Customer Outback FLEXware Surge Protector Models Introduction Electrical Connections and LED Indicators FLEXware Surge Protector SpecificationsLEDs Mounting Tools Required to Install Purpose ProcedureRemoving and installing FX M5 hex bolts Underside screw secures FW-SP-ACA to FX Remove these Two M5 hex bolts from the FX Removing various covers from the FX Preparing and installing the FW-SP-ACA onto an FX FW-SP-ACA slides onto the FX FW-SP-ACA slides down FX slots Screws included secure the FW-SP-ACA to an FX FW-SP-250 FW-SP-250 FW250 to check the placement of wires and components FW-ACA housing Locating pin FW-SP-R Replacement for the FW-SP-ACA or the FW-ACAProcedure Figures 12 FW-SP-R and FW-ACA Bracket FW-SP-R LEDs FW-SP-R installed inside the FW-ACA LED label FW-SP-R Replacement for the FW-SP-250 Securing wires to FX DC terminals Wiring and Connecting the FLEXware Surge Protector FLEXware Surge Protector Wiring Designations System can now be powered up FLEXware Surge Protector Limited Warranty Revision System Owner Surge Protector Limited Warranty RegistrationArlington, WA 19009 62nd Avenue NE +34