Pioneer DVH-P5900MP Understanding auto TA and EQ error messages, Error messages on the display

Appendix

Additional Information

Message	Cause	Action
PROTECT	All the files on the inserted disc are	Replace disc.
	secured by digital rights manage-
	ment (DRM)

Error messages on the display

Message	Cause	Action
ERROR-02-XX	Dirty disc	Clean disc.
	Scratched disc	Check that the disc is loaded correctly.
	The disc is loaded upside down	Check that the disc is loaded correctly.
THERMAL PROTECTION IN	The temperature of this unit is out-	Wait until the unit’s temperature returns to
MOTION	side the normal operating range	within normal operating limits.
DIFFERENT REGION DISC	The disc does not have the same re-	Replace the DVD video with one bearing the
	gion number as this unit	correct region number.
NON-PLAYABLE DISC	This type of disc cannot be played	Replace the disc with one this unit can play.
	by this unit
PROTECTED DISC	All the files on the inserted disc are	Replace disc.
	secured by digital rights manage-
	ment (DRM)

Understanding auto TA and EQ error messages

When correct measurement of car interior acoustic characteristics is not possible using the auto TA and EQ, an error message may appear on the display. If an error message appears, refer to the table below to see what the problem is and the suggested method of correcting the problem. After checking, try again.

Message	Cause	Action
ERR_MIC	Microphone is not connected.	Plug the supplied microphone securely into
		the jack.

ERR_FSP, ERR_FLSP, ERR_FRSP, ERR_CSP, ERR_RSP, ERR_RLSP, ERR_RRSP, ERR_SW

The microphone cannot pick up the measuring tone of a speaker.

!Confirm that the speakers are connected correctly.

!Correct the input level setting of the power amp connected to the speakers.

!Set the microphone correctly.

ERR_NOIS	The surrounding noise level is too
	high.

!Stop your car in a place that is as quiet as possible, and switch off the engine, air condi- tioner or heater.

!Set the microphone correctly.

84 En