DSP

Symptom Cause Action(See)
Speakersare not available to be
adjusted.
Theirsize settings is at OFF. Makethe correct size settings. (Page 76)
Timealignment is not available. Listeningposition is not set cor-
rectly.
Setlistening position correctly. (Page 70)
Speakersize settings is at OFF. Makethe correct size settings. (Page 76)
Thesubwoofer is not available to
switchits phase.
Thesubwoofer is set to OFF. Setthe subwoofer to ON. (Page76)
Basscontent is not heard. Thesubwoofer is set to OFF and yet
otherspeakers are set to OFF or
SMLin size.
Makethe correct settings. (If no subwoofer is
installed,the front or rear speaker needs to
beset to LRG.) (Page 76)
Ocassionallyno sounds are out-
putwhen Dolby Pro Logic II is
turnedon.
Thecenter speaker setting is at SML
orLRG whereas no center speaker
isinstalled.
Changethe center speaker size setting to
OFF.(If the audio source is mono and Dolby
ProLogic II is turned on, sound is heard over
thecenter speaker only.) (Page 76)
Occasionallyno sounds are
heardover speakers other than
thecenter one.
DolbyPro Logic II is turned on. TurnDolby Pro Logic II off. (If the audio
sourceis mono and Dolby Pro Logic II is
turnedon, sound is heard over the center
speakeronly.) (Page 70)
Turningdynamic range control
onhas no effects.
Thecurrently reproduced sound is
notDolby Digital coded.
Thefeature is only effective on Dolby Digital
sounds.(Page 71)
Nosounds are heard. Opticalcables are incorrectly con-
nected.
Connectthe cables correctly.
Error messages

Whenyou contact your dealer or your nearest Pioneer Service Center, be sure to record the error

message.

Message Cause Action
ERROR02-XX Dirtydisc Cleandisc.
Scratcheddisc Replacedisc.
Thedisc is loaded upside down Checkthat the disc is loaded correctly.
RERROR Thedisc does not have the same re-
gionnumber as this unit
Replacethe DVD video with one bearing the
correctregion number.
NON-PLAY Thistype of disc cannot be played
bythis unit
Replacethe disc with one this unit can play.
HEAT Thetemperature of this unit is out-
sidethe normal operating range
Waituntil the units temperature returns to
withinnormal operating limits.
Additional Information
En 83
Appendix
AdditionalInformation