Pioneer DVH-P5900MP operation manual Storing and recalling broadcast frequencies, Band

Section

03 Operating this unit

Non-RDS or MW/LW

 



1Band indicator

2Preset number indicator

3Frequency indicator

4Stereo (5) indicator

Shows when the selected frequency is being broadcast in stereo.

1Press SOURCE to select the tuner.

2Press BAND to select a band.

Press BAND until the desired band is dis- played, FM1, FM2, FM3 for FM or MW/LW.

3To perform manual tuning, briefly press cor d.

4To perform seek tuning, press and hold cor dfor about one second and release. The tuner will scan the frequencies until a broadcast strong enough for good reception is

found.

# You can cancel seek tuning by briefly pressing

cor d.

# If you press and hold cor dyou can skip sta- tions. Seek tuning starts as soon as you release the button.

Storing and recalling broadcast frequencies

If you press any of the preset tuning buttons 1 to 6 you can easily store up to six broadcast frequencies for later recall with the touch of a button.

!Up to 18 FM stations, six for each of the three FM bands, and six MW/LW stations can be stored in memory.

%When you find a frequency that you want to store in memory, press one of pre- set tuning buttons 1 to 6 and hold until the preset number stops flashing.

The number you have pressed will flash in the preset number indicator and then remain lit. The selected radio station frequency has been stored in memory.

The next time you press the same preset tun- ing button the radio station frequency is re-

called from memory.

# You can also use aand bto recall radio sta- tion frequencies assigned to preset tuning but- tons 1 to 6.

Introduction of advanced operations



1Function display

Shows the function status.

2LOC indicator

Shows when local seek tuning is on.

%Press FUNCTION repeatedly to switch between the following functions:

BSM (best stations memory)—REG (regional)

—LOCAL (local seek tuning)—TA (traffic an- nouncement standby)—AF (alternative fre-

quencies search)

# If MW/LW band is selected, you can only se-

lect BSM or LOCAL.

# To return to the frequency display, press

BAND.

# If you do not operate functions within about 30 seconds, the display is automatically returned to the ordinary display.

16 En