Outback Power Systems FX 2024 T installation manual LOW-VOLTAGE Wiring, Inverter and ON/OFF

LOW-VOLTAGE WIRING

This six-position terminal block can be unplugged to make wiring easier and to simplify the removal and reinstallation of an FX. It must be securely and completely plugged in for proper FX functioning. Otherwise, operational errors can occur.

Control Wiring Terminal Block

12 VDC at 0.7 amps (8.4 w) is available at the AUX+/AUX- terminals

A switch can be wired to the INVERTER and ON/OFF terminals to manually control the FX

XCT+/XCT- are not operational

����������

��������������

�����������������

�����������������

�������������

���������

��������������� �������� ������ ���� ���� ���� ����

������������
��������
������� ���� ��	���	������ �������� �����	�����

INVERTER and ON/OFF

•Replacing the pre-installed jumper connecting the ON/OFF terminals with a switch allows manual control of the FX.

•Without an ON/OFF switch, the inverter(s) will always be ON.

•Cycling the switch again returns the inverter to the ON mode.

INVERTER ON/OFF

Control Wiring Terminal Block, side view

Jumper

15