
Connections
– AC cord fixing |
| Close | Unplug the AC cord | |
|
| |||
|
| Push until |
| |
|
| the hook clicks. |
| |
| 1 Plug theAC cord into |
| Unplug the | |
| Open | AC cord | ||
| the display unit. | 2. Pull off. | pressing the | |
| Plug the AC cord until | |||
Note: |
| two knobs. | ||
it clicks. |
| |||
Make sure that the | 1. Keep the | Note: | ||
2 Fix the AC cord with | ||||
AC cord is locked on both | knob pressed. | When disconnecting the AC | ||
the left and right sides. | the clamper. | cord, be absolutely sure to | ||
| ||||
– Cable fixing bands |
|
| disconnect the AC cord plug | |
|
| at the socket outlet first. | ||
Secure any excess cables with bands as required. |
|
Note:
Two fixing bands are supplied with this unit. In case of securing cables at four positions, please purchase it separately.
Pass the attached cable fixing band through the clip as shown in the figure.
1
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.
| To tighten: | To loosen: |
| Push the catch | |
|
| |
| Pull |
|
2 |
| Pull |
12